Touch

Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012

Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012

This breakout board is the simplest way to create a project with a single "toggle" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to activate the sensor.

5,50 EUR

inkl. 19 % MwSt zzgl. Versandkosten

Lieferzeit: 24 Stunden

Kein Lagerbestand

Kein Lagerbestand

Kein Lagerbestand
Standalone Momentary Capacitive Touch Sensor Breakout - AT42QT1010

Standalone Momentary Capacitive Touch Sensor Breakout - AT42QT1010

This breakout board is the simplest way to create a project with a single "momentary" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to activate the sensor.

5,50 EUR

inkl. 19 % MwSt zzgl. Versandkosten

Lieferzeit: 24 Stunden

Kein Lagerbestand

Kein Lagerbestand

Kein Lagerbestand
Standalone 5-Pad Capacitive Touch Sensor Breakout - AT42QT1070 -

Standalone 5-Pad Capacitive Touch Sensor Breakout - AT42QT1070 -

This breakout board is the simplest way to create a project with mutiple capacitive touch sensors. No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins. When a capacitive load is detected (e.g. a person touches one of the conductive contacts) the corresponding LED on the right lights up and the output pin goes low. You can use this to update an existing normal-button project where buttons connect to ground when pressed.

6,95 EUR

inkl. 19 % MwSt zzgl. Versandkosten

Lieferzeit: 24 Stunden

Kein Lagerbestand

Kein Lagerbestand

Kein Lagerbestand