Standalone 5-Pad Capacitive Touch Sensor Breakout - AT42QT1070 -

6,95 EUR

inkl. 19 % MwSt zzgl. Versandkosten

Lieferzeit: 24 Stunden

Kein Lagerbestand

Kein Lagerbestand

0 Bewertung(en) | Bewertung schreiben

Art.Nr.: AF1362
Kein Lagerbestand

This breakout board is the simplest way to create a project with mutiple capacitive touch sensors. No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins. When a capacitive load is detected (e.g. a person touches one of the conductive contacts) the corresponding LED on the right lights up and the output pin goes low. You can use this to update an existing normal-button project where buttons connect to ground when pressed.

Note that only one contact will be detected at once (this is to protect against having a hand brush against two or more contacts at once.

Comes with a fully assembled board, and a stick of 0.1" header so you can plug it into a breadboard. For contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout.

The datasheet has many details on sensitivity, power usage, etc.  - note that this board uses the chip in 'standalone' mode only, it cannot be used in I2C mode. 

AT42QT1070 (pdf | 510kb)
Adafruit Capacitive Touch Sensor Breakouts. Add a Touch Sensor to your Project!:-)

Kunden kauften auch

Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
5,50 EUR
Vibrating Mini Motor Disc
1,75 EUR
SMT Breakout PCB for 44-QFN or 44-TQFP - 1 PCB
2,55 EUR - 2,15 EUR
Mini 8x8 LED Matrix w/I2C Backpack - Green
9,90 EUR
SMT Breakout PCB for SOIC-8, MSOP-8 or TSSOP-8 - 1 PCB -
0,75 EUR - 0,60 EUR
Adafruit Bicolor LED Square Pixel Matrix with I2C Backpack
14,85 EUR