Arduino Ethernet Pro

46,40 EUR

inkl. 19 % MwSt zzgl. Versandkosten

Lieferzeit: Gewöhnlich versandfertig in 24 Stunden

Kein Lagerbestand

Kein Lagerbestand

0 Bewertung(en) | Bewertung schreiben

Art.Nr.: ETHERNET-PRO
Kein Lagerbestand

Description: Ever wonder what would happen if you stacked an Ethernet shield on an Arduino Pro microcontroller and ran over it with a steam roller? Well, it would probably just break. But in a cartoon world it might turn into the Ethernet Pro! The Ethernet Pro is an Arduino-sized, shield-compatible microcontroller with all of the functionality of the Ethernet shield built right in!

The Ethernet Pro is based on the same hardware as the Ethernet shield (Wiznet W5100) in the same configuration so it is a drop-in replacement for the "Arduino/Ethernet double-stack," and works with all of the existing Ethernet shield libraries and code. This board features the 'Optiboot' bootloader, so be sure to select "Arduino Uno" in the Arduino IDE when you program it. The board can be programmed using either an FTDI Basic or the ATmega8U2 breakout (w/ USB-to-Serial firmware).

Note: The W5100 consumes a lot of power, so it's normal for it to run pretty warm. The regulator can also get pretty toasty, especially when it's dropping down higher voltages. For best operation, we recommend keeping the input voltage below 9V.

Documents:



Kunden kauften auch

FTDI Cable 5V
16,95 EUR
Saleae Logic-to-Wires
7,95 EUR
Saleae Logic-to-1x9 Header
11,95 EUR
Saleae 16-Kanal Logikanalysator
284,90 EUR
SL1X40M
0,49 EUR