• WiFi Breakout with uFL Connector for Ext Antenna

    WiFi Breakout with uFL Connector for Ext Antenna
    The CC3000 hits that sweet spot of usability, price and capability. It uses SPI for communication (not UART!) so you can push data as fast as you want or as slow as you want.

    32,50 EUR

    inkl. 19 % MwSt zzgl. Versandkosten

    Lieferzeit: 24 Stunden

    Details
  • 1.2" 4-Digit 7-Segment Display w/I2C Backpack - Green -

    1.2" 4-Digit 7-Segment Display w/I2C Backpack - Green -
    What's better than a single LED? Lots of LEDs! A fun way to make a numeric display is to use a 4-digit 7-segment display.

    19,85 EUR

    inkl. 19 % MwSt zzgl. Versandkosten

    Lieferzeit: 24 Stunden

    Details
  • PN532 NFC/RFID controller breakout board

    PN532 NFC/RFID controller breakout board
    The PN532 is the most popular NFC chip, and is what is embedded in pretty much every phone or device that does NFC. It can pretty much do it all, such as read and write to tags and cards, communicate with phones (say for payment processing), and 'act' like a NFC tag. If you want to do any sort of embedded NFC work, this is the chip you'll want to use!

    39,80 EUR

    inkl. 19 % MwSt zzgl. Versandkosten

    Lieferzeit: 24 Stunden

    Details
  • Standalone 5-Pad Capacitive Touch Sensor Breakout - AT42QT1070 -

    Standalone 5-Pad Capacitive Touch Sensor Breakout - AT42QT1070 -
    This breakout board is the simplest way to create a project with mutiple capacitive touch sensors. No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins. When a capacitive load is detected (e.g. a person touches one of the conductive contacts) the corresponding LED on the right lights up and the output pin goes low. You can use this to update an existing normal-button project where buttons connect to ground when pressed.

    6,95 EUR

    inkl. 19 % MwSt zzgl. Versandkosten

    Lieferzeit: 24 Stunden

    Details